Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
NOTE:
On the scan tool, the powertrain relay is referred to as the EC ignition relay.
- If DTCs P0685 or P0690 are set, diagnosis those DTCs first.
- Ignition ON, observe the scan tool Ignition 1 Signal and the EC Ignition Relay Feedback Signal parameters. There should be no more than 3 V difference between the 2 parameters.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.