Component Testing
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
You must perform the Circuit/System Testing before proceeding with Component Testing.
- Inspect the CKP sensor for correct installation. Remove the CKP sensor from the engine and inspect the sensor and the O-ring for damage.
- If the sensor is loose, incorrectly installed, or damaged, repair or replace the CKP sensor.
- Connect the CKP sensor connector to the CKP sensor.
- Ignition ON and engine OFF. Observe the CKP Active Counter while passing a steel object across the tip of the sensor repeatedly. The CKP Active Counter parameter should increment.
- If the parameter does not increment, replace the CKP sensor.