Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify that the following DTCs are not set: P0641 or P0651.
- If any of the DTCs are set, refer to DTC P0641 or P0651 .
- Ignition ON, observe the scan tool MAP sensor parameters. The readings should be between 0.05-4.9 volts.
- Engine running, observe the DTC information with a scan tool. DTCs P0107 or P0108 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.