LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Controls And Fuel - 4.6L (LH2) - DTC P0010 To DTC P0333) >> DTC P0030, P0036, P0053, P0054, P0135, or P0141 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Allow the engine to reach operating temperature. With the engine running, observe the HO2S Heater parameter with a scan tool. The value should vary from below 3.125 amp to above 0.25 amp.
  2. With the engine running at operating temperature, observe the HO2S Heater parameter with a scan tool and manipulate the related wiring and connectors.
    • If manipulation does affect the parameter then repair the harness or connector.
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals