Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0010, P0013, P0016, P0017, P0018, P0019, P0020, P0023,, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390, P0391, P2088, P2089, P2090, P2091, P2092, P2093, P2094, P2095 are not set.
The CMP actuators are commanded.
The engine oil pressure (EOP) is between 100-696.4 kPa (14.5-101 psi).
The engine speed is at an RPM between 1,000-6,500 RPM, that will allow for steady activation of the cam actuators based on calculated engine oil temperature (EOT).
The calculated EOT is between -10 to +150°C (+14 to +302°F).
The ignition voltage is between 9-18 volts.
DTC P0011, P0014, P0021, or P0024 runs continuously when the above conditions are met.