LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 3 Of 3) >> Oil Pump Suction Pipe and Screen Assembly Installation

Oil Pump Suction Pipe and Screen Assembly Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Pump Pipe Gasket
    GM928635Courtesy of GENERAL MOTORS CORP.
  1. Install NEW oil pump pipe gasket on oil pump pipe.
    2. Fig 2: Oil Pump Pipe & Screen Assembly
    GM1346218Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the oil pump pick-up retaining bolt and nut.
    • Tighten the oil pump pick-up tube nut to 24 N.m (18 lb ft) .
    • Tighten the oil pump pick-up tube bolt to 10 N.m (89 lb in) .
scientia non olet · About LEMON Manuals