P/S Pump and A/C Compressor Drive Belt Tensioner

WARNING: This page is about a different variant/trim than selected.

Fig 1: P/S Pump & A/C Compressor Drive Belt Tensioner

Courtesy of GENERAL MOTORS CORP.

Place the P/S pump and A/C compressor drive belt tensioner in position to the camshaft position actuator housing. Ensure to properly locate the dive belt tensioner anchor pin in the recess in the camshaft position actuator housing.

CAUTION: Refer to Fastener Caution .

Install the P/S pump and A/C compressor drive belt tensioner bolt and tighten to 50 N.m (37 lb ft).