LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 3 Of 3) >> Drive Belt Tensioner Installation >> Generator Drive Belt Tensioner

Generator Drive Belt Tensioner

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Generator Bracket & Bolts
    GM1346196Courtesy of GENERAL MOTORS CORP.
  1. Place the generator bracket in position to the engine.
    2. CAUTION: Refer to Fastener Caution .
  2. Loosely install the generator bracket bolts.
  3. Tighten the generator bracket bolts in proper sequence.
    • Tighten the generator bracket front upper bolt to 50 N.m (37 lb ft).
    • Tighten the generator bracket rear upper bolt to 50 N.m (37 lb ft).
    • Tighten the generator bracket lower bolt to 50 N.m (37 lb ft).
    4. Fig 2: Generator Drive Belt Tensioner & Bolt
    GM1346194Courtesy of GENERAL MOTORS CORP.
  4. Place the generator drive belt tensioner in position to the generator bracket. Ensure to properly locate the drive belt tensioner anchor pin in the recess in the generator bracket.
  5. Install the generator drive belt tensioner bolt and tighten to 50 N.m (37 lb ft).
scientia non olet · About LEMON Manuals