LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 3 Of 3) >> Drive Belt Idler Pulley Installation

Drive Belt Idler Pulley Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Idler Pulley
    GM1346188Courtesy of GENERAL MOTORS CORP.
  1. Place the drive belt idler pulley in position to the engine.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the drive belt idler pulley bolt and tighten to 50 N.m (37 lb ft).
scientia non olet · About LEMON Manuals