LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 3 Of 3) >> Crankshaft and Bearing Installation >> Crankshaft Installation Procedure

Crankshaft Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Crankshaft Sprocket Drive Pin
    GM947623Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW crankshaft sprocket drive pin (1), if removed due to damage.
    2. Fig 2: Proper Pin Height
    GM685378Courtesy of GENERAL MOTORS CORP.
  2. Ensure pin height (1) is 2.75-3.25 mm (0.0689-0.1280 in).
    3. Fig 3: Crankshaft
    GM947617Courtesy of GENERAL MOTORS CORP.
  3. Gently lower the crankshaft into position in the cylinder block.
  4. Ensure the crankshaft turns without binding or noise.
scientia non olet · About LEMON Manuals