LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - On Vehicle - 1 Of 2) >> Engine Oil Level Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Level Switch
    GM1213854Courtesy of GENERAL MOTORS CORP.
  1. Install the engine oil level switch to the oil pan.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the engine oil level switch bolt and tighten to 10 N.m (89 lb in).
  3. Connect the electrical connector to engine oil level switch.
  4. Fill the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  5. Inspect for oil leaks after engine start up.
scientia non olet · About LEMON Manuals