LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - On Vehicle - 1 Of 2) >> Engine Mount Replacement - Right Side (with AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Mount Retaining Nuts
    GM1067552Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the engine mount retaining nut and tighten to 80 N.m (59 lb ft).
  3. Install the right engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side (RWD)  or Engine Mount Bracket Replacement - Right Side (with AWD) .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals