LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - On Vehicle - 1 Of 2) >> Engine Mount Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Left Engine Mount Bracket
    GM888296Courtesy of GENERAL MOTORS CORP.
  1. Install the left engine mount brackets.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the left engine mount bracket retaining bolts and tighten to 60 N.m (44 lb ft).
    3. Fig 2: Upper Engine Mount & Retaining Nut
    GM888298Courtesy of GENERAL MOTORS CORP.
  3. Install the upper engine mount retaining nut and tighten to 80 N.m (59 lb ft).
  4. Remove the screw jack.
  5. Install the left exhaust manifold. Refer to Exhaust Manifold Removal - Left Side .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals