LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - On Vehicle - 1 Of 2) >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Idler Pulley
    GM887830Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt idler pulley.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the drive belt idler pulley bolt and tighten to 50 N.m (37 lb ft).
  3. Install the drive belt. Refer to Water Pump and Air Conditioning Compressor and Power Steering Pump Belt Replacement .
scientia non olet · About LEMON Manuals