Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Right Camshaft Actuator Housing

Courtesy of GENERAL MOTORS CORP.

Remove the right actuator housing. DO NOT remove the camshaft position (CMP) actuator solenoids from the housing. Refer to Camshaft Position Actuator Housing Replacement - Right Side .
Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .

NOTE: The secondary timing chain has black links that are used for alignment when the primary and secondary timing gear and chain assemblies are being installed together. IT IS NOT NECESSARY for the black chain links to be aligned with the camshaft actuator timing marks when the secondary chain and gear components are being serviced separately.

Using the J 39946 , rotate the crankshaft until both bank 1 (right) CMP actuator timing marks are perpendicular (90 degrees) to the cylinder head deck surface and near the top of their rotation. See Special Tools .

Fig 2: Camshaft Holding Tool

Courtesy of GENERAL MOTORS CORP.

WARNING: Refer to Camshaft Holding Tool Warning .

Install the EN 46328 (1) to the camshafts (2). See Special Tools .

Fig 3: Creating Mark On Timing Chain Link Adjacent To Each Camshaft Sprocket Timing Mark

Courtesy of GENERAL MOTORS CORP.

Use a paint stick to create a mark (1) on the timing chain link adjacent to each camshaft position actuator timing mark (2, 3).

Fig 4: Timing Chain Retention Tool Components

Courtesy of GENERAL MOTORS CORP.

Install the EN 46327 (1) using the installation of the EN 46327 timing chain retention tool procedure. See Special Tools .