LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - On Vehicle - 1 Of 2) >> Camshaft Cover Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Split Line Of Right Cylinder Head & Camshaft Position Actuator Housing
    GM1242793Courtesy of GENERAL MOTORS CORP.
    NOTE: Be careful to prevent the exposed section of the camshaft cover seal from being damaged by the edge of the cylinder head casting.
  1. Install the camshaft cover gasket as required.
  2. Place a small amount of sealant at the split line (1, 2) of the right cylinder head and the right camshaft position actuator housing. Refer to Adhesives, Fluids, Lubricants, and Sealers .
    3. Fig 2: Right Camshaft Cover & Bolts
    GM928273Courtesy of GENERAL MOTORS CORP.
  3. Install the camshaft cover.
    4. Fig 3: Right Camshaft Cover Ground Strap & Bolt
    GM928269Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Install the camshaft cover bolts installing the ground strap to the camshaft cover and tighten to 10 N.m (89 lb in).
  5. Install the bank 1 ignition coils. Refer to Ignition Coil Replacement - Bank 1 .
  6. Connect the cable harness clips to the front of the camshaft cover.
  7. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    8. Fig 4: Right Cylinder Head Wiring Harness Bracket Bolts
    GM887932Courtesy of GENERAL MOTORS CORP.
  8. Install the bolts securing the wire harness bracket to the cylinder head and tighten to 45 N.m (33 lb ft).
  9. Install the front air deflector. Refer to Front Air Deflector Replacement .
  10. Lower the vehicle.
    11. Fig 5: Battery Tray
    GM1296149Courtesy of GENERAL MOTORS CORP.
  11. Install the battery tray. Refer to Battery Tray Replacement .
    12. Fig 6: Front Air Inlet Housing Panel
    GM1332265Courtesy of GENERAL MOTORS CORP.
  12. Install the front air inlet housing panel. Refer to Air Inlet Housing Front Panel Replacement .
    13. Fig 7: PCV Dirty Air Tube
    GM928153Courtesy of GENERAL MOTORS CORP.
  13. Connect the PCV dirty air tube to the camshaft cover.
    14. Fig 8: Fuel Injector Sight Shield
    GM1272602Courtesy of GENERAL MOTORS CORP.
  14. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals