Hood Replacement

Fig 1: Hood

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Preliminary Procedure The primary hood latch striker is not serviceable separately from the hood. If the hood striker is damaged, the hood must be replaced. The hood striker bolts must be reused, or if damaged replaced with new hood striker bolts. If the hood and/or striker needs to be replaced. Remove the hood assist rod. Refer to Hood Open Assist Rod Replacement .
1	Hood Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 9 N.m (80 lb in)
2	Hood Tip: Disconnect any electrical connectors. Transfer any parts as needed.

Callout

Component Name

WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Preliminary Procedure

The primary hood latch striker is not serviceable separately from the hood. If the hood striker is damaged, the hood must be replaced. The hood striker bolts must be reused, or if damaged replaced with new hood striker bolts. If the hood and/or striker needs to be replaced.
Remove the hood assist rod. Refer to Hood Open Assist Rod Replacement .

Hood Bolt (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 9 N.m (80 lb in)

Hood
Tip:

Disconnect any electrical connectors.
Transfer any parts as needed.