Power Steering Pump Pulley Replacement

Power Steering Pump Pulley Replacement (RPO LH2)

Special Tools
* J 25033-C Power Steering Pump Pulley Installer
* J 25034-C Power Steering Pump Pulley Remover

Removal Procedure




1. Remove the accessory drive belt. Refer to Drive Belt Replacement (Drive Belt Replacement) for the 4.6L (LH2) engine.
2. Using the J 25034-C , remove the pulley from the power steering pump.

Installation Procedure




1. Using the J 25033-C , install the power steering pump pulley onto the power steering pump.





Important: The pulley must be installed onto pump shaft so that the pulley hub is flush to within 0.25 mm (0.010 in) with the pump shaft.


2. Install the accessory drive belt. Refer to Drive Belt Replacement (Drive Belt Replacement) for the 4.6L (LH2) engine.