Ambient Light Sensor: Service and Repair

Sunload and Twilight Sentinel Sensor Replacement

Removal Procedure




1. Remove the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement (Service and Repair).
2. Pull the wire lead outward from the I/P carrier and disconnect the sensor.

Installation Procedure




1. Connect the electrical lead to the sunload and twilight sentinel sensor.
2. Route the wiring harness into the I/P carrier and position the I/P trim pad into place.
3. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement (Service and Repair).