83. Engine Front Cover Assemble

Engine Front Cover Assemble





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the generator cooling inlet hose fitting.

Tighten the generator cooling inlet hose fitting to 25 Nm (18 lb ft).




2. Install the NEW thermostat gasket onto the thermostat.




3. Install the thermostat and gasket into the thermostat housing.




4. Install the thermostat housing.
5. Install the thermostat housing bolts.

Tighten the thermostat housing bolts to 10 Nm (89 lb in).




6. Install the NEW water pump O-ring.




7. Install the water pump.
8. Install the water pump bolts.

Tighten the water pump bolts to 10 Nm (89 lb in).