Lumbar Switch Replacement

Lumbar Switch Replacement

Removal Procedure

1. Remove the seat outer finish panel. Refer to Driver Seat Outer Finish Panel Replacement (Driver Seat Outer Finish Panel Replacement).




2. Use a small flat-bladed tool to release the switch from the finish panel. Remove the switch.




3. Disconnect the electrical connector to the lumbar switch.

Installation Procedure




1. Connect the electrical connector to the lumbar switch.




2. Install the lumbar switch to the finish panel. Press until the switch snaps into place.
3. Install the finish panel. Refer to Driver Seat Outer Finish Panel Replacement (Driver Seat Outer Finish Panel Replacement).