LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6L80 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Pipe Replacement - Rear >> Installation Procedure

Installation Procedure

  1. Install the TOC pipes into position.
  2. Install the rear TOC pipe bracket.
    3. CAUTION: Refer to Fastener Caution .
    Fig 1: View Of Rear TOC Pipe Bracket Bolt
    GM1200827Courtesy of GENERAL MOTORS CORP.
  3. Install the rear TOC pipe bracket bolt and tighten to 12 N.m (9 lb ft).
  4. Install the forward TOC pipe bracket.
    5. Fig 2: View Of Forward TOC Pipe Bracket Bolt
    GM1200824Courtesy of GENERAL MOTORS CORP.
  5. Install the forward TOC pipe bracket bolt and tighten to 12 N.m (9 lb ft).
  6. Remove caps or plugs from the TOC pipes and transmission fittings.
  7. Connect the upper and lower TOC pipes to the transmission.
  8. Rotate the TOC block fitting to secure the upper TOC pipe.
    9. Fig 3: View Of TOC Block Fitting Bolt
    GM1715289Courtesy of GENERAL MOTORS CORP.
  9. Install the TOC block fitting bolt to the transmission housing and tighten to 25 N.m (18 lb ft).
  10. Remove the caps or plugs from the TOC pipes.
    11. Fig 4: View Of TOC Inlet & Outlet Lines
    GM1218468Courtesy of GENERAL MOTORS CORP.
  11. Connect the front TOC inlet and outlet lines to the rear TOC inlet and outlet lines.
  12. Install the floor panel tunnel panel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement .
  13. Lower the vehicle.
  14. Check the transmission fluid level, add fluid if necessary. Refer to Transmission Fluid Check .
scientia non olet · About LEMON Manuals