LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6L80 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Shift Control Linkage Adjustment >> Adjustment Procedure

Adjustment Procedure

    Fig 1: Identifying Shift Control Cable Assembly Components
    GM932162Courtesy of GENERAL MOTORS CORP.
  1. Place the transmission shift control lever 2 into the NEUTRAL position.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 2: Identifying Shift Cable Secondary Lock
    GM1481064Courtesy of GENERAL MOTORS CORP.
  3. Slide the shift cable secondary lock (1) forward.
    4. Fig 3: Unlocking Shift Cable Primary Lock
    GM1481065Courtesy of GENERAL MOTORS CORP.
  4. With a small flat-blade screwdriver, reposition the shift cable primary lock (1) outward to UNLOCK the cable rod from the cable adjuster body.
  5. Ensure that the transmission range select lever and shifter are each in the NEUTRAL position.
    6. Fig 4: Identifying Cable Primary Lock
    GM1481066Courtesy of GENERAL MOTORS CORP.
  6. Press in on the cable primary lock (1) until seated.
  7. Slide the secondary lock rearward.
  8. Lower the vehicle.
    9. Fig 5: Identifying Shift Control Cable Assembly Components
    GM932162Courtesy of GENERAL MOTORS CORP.
  9. Place the transmission shifter control lever 2 into the PARK position. Ensure that the vehicle is prevented from rolling when the shifter selector lever is in the PARK position.
  10. Make sure that the starter motor will not operate when the shifter selector lever is placed in the reverse or drive position.
scientia non olet · About LEMON Manuals