Engine Coolant Thermostat Housing Replacement (LF1/LLT)

Fig 1: Identifying Engine Coolant Thermostat Housing (LF1/LLT)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the fuel pipe shield. Refer to Fuel Pipe Shield Replacement (LLT) . Disconnect the engine coolant inlet pipe. Refer to Engine Coolant Inlet Pipe Replacement . Disconnect the radiator inlet and outlet hoses. Refer to Heater Inlet Hose Replacement (LH2) or Heater Inlet Hose Replacement (LY7) and Heater Outlet Hose Replacement (LH2) or Heater Outlet Hose Replacement (LY7) . Disconnect the outlet pipe from the thermostat housing. Refer to Radiator Surge Tank Outlet Hose/Pipe Replacement (LH2) or Radiator Surge Tank Outlet Hose/Pipe Replacement (LY7) .
1	Thermostat Housing Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb ft)
2	Engine Coolant Thermostat Housing

Callout

Component Name

Preliminary Procedures

Thermostat Housing Bolt (Qty: 3)

CAUTION: Refer to Fastener Caution .

Tighten: 10 N.m (89 lb ft)

Engine Coolant Thermostat Housing