Suspension Control Module: Service and Repair

Electronic Suspension Control Module Replacement

Removal Procedure

1. Remove the right rear trim panel.




2. Loosen the electronic suspension control (ESC) module nuts (3).
3. Disconnect the ESC module electrical connector (1).
4. Remove the ESC module (2).

Installation Procedure




1. Install the ESC module (2).
2. Connect the ESC module electrical connector (1).

Caution: Refer to Fastener Caution (Fastener Caution).

3. Tighten the ESC module nuts to 9 Nm (80 lb in).
4. Install the right rear trim panel.
5. Refer to Control Module References (Programming and Relearning) for programming and setup information.