Hazard Warning Flasher: Service and Repair

Hazard and Turn Signal Flasher Replacement

Removal Procedure

1. Remove the driver side instrument panel (I/P) closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (Service and Repair) or Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).




2. Remove the flasher module (2) off the I/P carrier.
3. Disconnect the electrical connector (1).

Installation Procedure




1. Connect the electrical connector (1) to the flasher module (2).
2. Slide the flasher module retaining clip onto the I/P carrier.
3. Install the driver side I/P closeout/Insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (Service and Repair) or Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).