Removal Procedure

Remove the plastic caps from the quick connect fittings by pulling the caps back along the pipe before installation.

Fig 1: Installing J 41623-B Onto Generator Cooling Inlet Pipe

Courtesy of GENERAL MOTORS CORP.

Install the J 41623-B onto the transmission oil cooler (TOC) pipe, or use the. See Special Tools .J 28585

Fig 2: Sliding J 41623-B Toward Generator Cooling Inlet Pipe Fitting

Courtesy of GENERAL MOTORS CORP.

Slide the J 41623-B toward the TOC pipe fitting, or use the J 28585 . See Special Tools .

Fig 3: Rotating J 41623-B On Coolant Pipe

Courtesy of GENERAL MOTORS CORP.

NOTE: Rotate the J 41623-B to engage the TOC pipe fitting's retainer slots. See Special Tools .
The J 41623-B should be nearly flush with the fitting. See Special Tools .

Connect the J 41623-B onto the TOC pipe fitting. See Special Tools .

Fig 4: Rotating J 41623-B Until Retainer Clip Rises Above Fitting Retainer Seat

Courtesy of GENERAL MOTORS CORP.

Rotate the J 41623-B or use the J 28585 until the retainer clip (1) rises above the fitting retainer seat.

Fig 5: Removing J 41623-B From Generator Cooling Inlet Pipe

Courtesy of GENERAL MOTORS CORP.

Pull back on the TOC pipe to disengage the pipe from the TOC pipe fitting.
Remove the J 41623-B or the J 28585 from the TOC pipe. See Special Tools .