Installation Procedure

Fig 1: View Of Range Selector Cable & Cable Bracket Retainer

Courtesy of GENERAL MOTORS CORP.

Ensure that the transmission manual shaft lever is in the mechanical park position.
Align and install the range selector cable (2) to the bracket.
Install the retainer (1) that secures the cable to the bracket.
Install the range selector cable end to the transmission range selector lever ball stud.
Install the cable clip on the transfer case, if equipped.

Fig 2: View Of Cable Clips At Floor Panel Reinforcement

Courtesy of GENERAL MOTORS CORP.

Install the clips on the cable to the floor panel reinforcement.
Lower the vehicle and ensure that the steering column shift lever is still in the park position.

Fig 3: View Of Cable Grommet At Floor Panel

Courtesy of GENERAL MOTORS CORP.

Fig 4: View Of Range Selector Cable

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Avoid unnecessary twisting/bending of the range selector cable when installing the cable to the support.

Fig 5: View Of Cable, Steering Column Ball Stud & Steering Column Bracket

Courtesy of GENERAL MOTORS CORP.

Fig 6: View Of Steering Cable Retainer On Steering Column

Courtesy of GENERAL MOTORS CORP.

Install the retainer securing the cable to the steering column.
Position the carpet and insulation around the driver area.
Install the driver seat. Refer to Front Seat Replacement - Bucket (Tahoe with HP2) or Front Seat Replacement - Bucket (without HP2) .
Install the instrument panel knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) or Knee Bolster Replacement (Cadillac) .
Test the transmission for proper shift operation.
If all of the gear positions cannot be achieved, adjust the cable. Refer to Range Selector Lever Cable Adjustment .