Input and Output Speed Sensor Replacement

Fig 1: Replacing Input and Output Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement . Remove the upper and lower valve body assembly. Refer to Control Valve Lower Body and Upper Body Replacement .
1	Speed Sensor Electrical Connector
2	Input and Output Speed Sensor Assembly Bolts (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 12 N.m (106 lb in)
3	Input and Output Speed Sensor Assembly Clips (Qty: 2) Tip: Inspect the wiring harness clips for damage replace if necessary.
4	Input and Output Speed Sensor Assembly