LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Automatic Transmission Fluid Pressure Test Hole Plug Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Oil Pressure Test Plug
    GM1649737Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the oil pressure test plug.

    Tighten:  Tighten the oil pressure test plug to 11 N.m (97 lb in).

  2. Check the transmission fluid level (fill if necessary). Refer to Transmission Fluid Check .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals