Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Wheel Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Install the wheel speed sensor (1) to the rear axle.

Fig 2: Identifying Rear Wheel Speed Sensor Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).

Fig 3: Identifying Rear Wheel Speed Sensor Electrical Connector & Harness Clips

Courtesy of GENERAL MOTORS CORP.

Connect the wheel speed sensor electrical connector (1).
Install the wheel speed sensor electrical connector and sensor harness clips (2) to the inboard frame rail.
Perform the Diagnostic System Check - Vehicle .