Front Wheel Speed Sensor Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Wheel Speed Sensor & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to Brake Dust Warning . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation . Remove the brake rotor. Refer to Front Brake Rotor Replacement (2500 Series) or Front Brake Rotor Replacement (1500 Series) .
1	Wheel Speed Sensor Electrical Connector Clip Procedure Disconnect the electrical connector. Release the wheel speed sensor electrical connector clip from the brake hose bracket.
2	Wheel Speed Sensor Harness Clip Procedure: Release the wheel speed sensor harness clip from the brake hose bracket.
3	Wheel Speed Sensor Harness Clip Procedure: Release the wheel speed sensor harness clip from the steering knuckle bracket.
4	Wheel Speed Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten: 18 N.m (13 lb ft)
5	Wheel Speed Sensor Procedure: Perform the Diagnostic System Check - Vehicle .