Master Cylinder Replacement (JD9)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Master Cylinder Replacement (JD9)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to Brake Fluid Irritant Warning . CAUTION: Refer to Brake Fluid Effects on Paint and Electrical Components Caution . Preliminary Procedures With the engine OFF, apply the brake pedal several times until the brake pedal becomes firm to deplete the vacuum brake booster vacuum reserve. Using a suitable tool, remove the brake fluid from the brake master cylinder reservoir. Discard the brake fluid into an approved container.
1	Master Cylinder Fluid Level Sensor Electrical Connector
2	Brake Pipe Fitting (Qty: 2) CAUTION: Refer to Fastener Caution . Procedure Remove any dirt or debris from the brake pipe fitting. Cap the brake pipe fittings to prevent brake fluid loss and contamination. Tighten: 32 N.m (24 lb ft)
3	Brake Master Cylinder Nut (Qty: 2) Tighten: 36 N.m (27 lb ft)
4	Brake Master Cylinder Assembly
5	Brake Master Cylinder to Vacuum Booster Seal Procedure Inspect the brake master cylinder to vacuum booster seal for damage and replace if necessary. Ensure the brake master cylinder to vacuum booster seal is properly seated against the base of the brake master cylinder. Do not place the brake master cylinder to vacuum booster seal in the groove of the master cylinder body. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .