Radio Replacement (Except Cadillac)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Radio Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Use a scan tool to retrieve the radio part number before removing the radio from the vehicle. Preliminary Procedures Remove the accessory switch assembly. Refer to Accessory Switch Replacement (Except Cadillac) or Accessory Switch Replacement (Cadillac) . Remove the HVAC control module. Refer to HVAC Control Module Replacement or HVAC Control Module Replacement .
1	Radio Screw (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Radio Assembly Tip: Disconnect the electrical connector. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References .

Callout

Component Name

NOTE: Use a scan tool to retrieve the radio part number before removing the radio from the vehicle.

Preliminary Procedures

Remove the accessory switch assembly. Refer to Accessory Switch Replacement (Except Cadillac) or Accessory Switch Replacement (Cadillac) .
Remove the HVAC control module. Refer to HVAC Control Module Replacement or HVAC Control Module Replacement .

Radio Screw (Qty: 4)

CAUTION: Refer to Fastener Caution .

Tighten: 2 N.m (18 lb in)

Radio Assembly
Tip:

Disconnect the electrical connector.
Disconnect the antenna cable.
Reprogram the radio after replacement. Refer to Control Module References .