Knee Bolster Replacement (Cadillac)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Knee Bolster Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Left Outer Trim Cover Tip: Refer to Instrument Panel Outer Trim Cover Replacement (Cadillac) .
2	Knee Bolster Assembly Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
3	Knee Bolster Assembly Procedure Disconnect the electrical connections, if applicable. If replacing the knee bolster assembly, transfer all necessary components.
4	Retainer Clip (Qty: 4)