Instrument Cluster Trim Panel Replacement (Cadillac)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Instrument Panel Cluster Trim Plate Bezel & Clips

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Cadillac) . Remove the left instrrument panel outer air outlet deflector. Refer to Instrument Panel Outer Air Outlet Deflector Replacement - Left Side (Cadillac) .
1	Instrument Panel Cluster Trim Plate Bezel Procedure Position the steering wheel to its lowest possible position. Use a flat-bladed plastic trim tool in order to release the retainer clips securing the lower edge of the trim plate to the instrument panel. Pull the trim bezel downward, releasing the tabs at the upper edge of the bezel from the instrument panel upper trim panel.
2	Retainer Clips (Qty: 4)

Callout

Component Name

Preliminary Procedure

Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Cadillac) .
Remove the left instrrument panel outer air outlet deflector. Refer to Instrument Panel Outer Air Outlet Deflector Replacement - Left Side (Cadillac) .

Instrument Panel Cluster Trim Plate Bezel

Procedure

Position the steering wheel to its lowest possible position.
Use a flat-bladed plastic trim tool in order to release the retainer clips securing the lower edge of the trim plate to the instrument panel.
Pull the trim bezel downward, releasing the tabs at the upper edge of the bezel from the instrument panel upper trim panel.

Retainer Clips (Qty: 4)