Center Pillar Lower Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Center Pillar Lower Garnish Molding Assembly & Retainers

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove front door sill plate. Refer to Front Side Door Sill Trim Plate Replacement . Remove rear door sill plate. Refer to Rear Side Door Sill Trim Plate Replacement (Extended Wheelbase) or Rear Side Door Sill Trim Plate Replacement (Standard Wheelbase) .
1	Center Pillar Lower Garnish Molding Assembly Tip: Ensure seat belt webbing does not become trapped during installation. Tab to be fully seated and installed prior to retainer.
2	Center Pillar Lower Garnish Molding Retainer (Qty: 2)

Callout

Component Name

Preliminary Procedures

Remove front door sill plate. Refer to Front Side Door Sill Trim Plate Replacement .
Remove rear door sill plate. Refer to Rear Side Door Sill Trim Plate Replacement (Extended Wheelbase) or Rear Side Door Sill Trim Plate Replacement (Standard Wheelbase) .

Center Pillar Lower Garnish Molding Assembly
Tip:

Ensure seat belt webbing does not become trapped during installation.
Tab to be fully seated and installed prior to retainer.

Center Pillar Lower Garnish Molding Retainer (Qty: 2)