Body Rear Corner Garnish Molding Replacement - Right Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Body Rear Corner Upper Garnish Molding Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable the roof rail SIR system. Refer to SIR Disabling and Enabling . Remove the rear opening garnish molding. Refer to Rear Door Upper Garnish Molding Replacement .
1	Body Rear Corner Upper Garnish Molding Cover Tip: Disconnect the 2 electrical connectors.
2	Body Rear Corner Upper Garnish Molding Screw CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
3	Body Rear Corner Upper Garnish Molding Assembly
4	Body Rear Corner Upper Garnish Molding Clip (Qty: 3)
5	Body Rear Corner Upper Garnish Molding Retainer (Qty: 3)