Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Body Lock Pillar Garnish Molding Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable roof rail SIR system. Refer to SIR Disabling and Enabling . Remove rear side door sill plate. Refer to Rear Side Door Sill Trim Plate Replacement (Extended Wheelbase) or Rear Side Door Sill Trim Plate Replacement (Standard Wheelbase) .
1	Body Lock Pillar Garnish Molding Plug
2	Body Lock Pillar Garnish Molding Screw CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
3	Removable Midgate Hinge Finish Cover
4	Rear Belt Assembly Anchor Bolt Tighten: 70 N.m (52 lb ft)
5	Body Lock Pillar Garnish Molding Assembly Tighten: 43 N.m (32 lb ft) Tip: Remove seat belt D-ring from the adjuster assembly. Route seat belt through garnish molding.
6	Body Lock Pillar Garnish Molding Retainer (Qty: 5)