| 2-6 and 3-5-R Clutch Hub Thrust Bearing Assembly (65) |
Inspect the bearing for wear or damage. |
| Output Carrier Assembly (68) |
- Inspect the carrier assembly for damaged pinion gears, thrust washers, pins, and rollers.
- Inspect for a damaged center support roller bearing assembly (485).
- Inspect for damaged thrust bearings (486, 488).
- Inspect for damaged sun gears (487, 489).
- Inspect the carrier assembly for damaged output carrier rear sun gear thrust bearing (captured).
- Inspect for damaged or stripped splines on the output carrier assembly.
|
| Output Carrier Thrust Bearing Assembly (69) |
Inspect the bearing for wear or damage. |
| Output Shaft Assembly (70) |
- Inspect for damaged internal gears (495, 497).
- Inspect the output carrier bushing (498) for damage or wear.
|
| Output Shaft Thrust Bearing Assembly (71) |
Inspect the bearing for wear or damage. |
| Input Sun Gear Thrust Washer (55) |
Inspect the washer for wear or damage. |
| Input Sun Gear Thrust Bearing (54) |
Inspect the bearing for wear or damage. |
| Input Sun Gear (53) |
Inspect for spline wear or damage. |
| Input Carrier Assembly (52) |
Inspect the carrier assembly for damaged pinion gears, thrust washers, pins, and rollers. |
| 1-2-3-4 Clutch Hub Thrust Bearing Assembly (63) |
Inspect the bearing for wear or damage. |
| 2-6 and 3-5-R Clutch (with Output Carrier Outer Sun Gear Shaft) Hub Assembly (64) |
Inspect the output carrier inner sun gear shaft bushings (60 and 62) for damage or wear. |
| Turbine Shaft Thrust Bearing Assembly (57) |
Inspect the bearing for wear or damage. |
| Fluid Filter Assembly (26) |
- Inspect for damaged or restricted fluid filter assembly (26)
- Inspect for damaged fluid filter seal assembly (25) or improper sealing interface (leaks, fluid aeration).
|
| Automatic Transmission Fluid Pump Seal (5) |
Inspect for worn or damaged seal. |