Air Inlet Assembly Replacement

Fig 1: View Of Air Inlet Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the HVAC module assembly. Refer to HVAC Module Assembly Replacement (Non-HP2) or HVAC Module Assembly Replacement (HP2) . Disconnect the electrical connector from the recirculation actuator.
1	Recirculation Actuator Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 1.5 N.m (13 lb in)
2	Recirculation Actuator
3	Air Inlet Assembly Screw (Qty: 2) Tighten: 1.5 N.m (13 lb in)
4	Air Inlet Assembly Tip: Tilt the rear of the air inlet assembly upward to release front mounting tabs.