LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF/IAT Sensor Adapter & Clamp
    GM1703691Courtesy of GENERAL MOTORS CORP.
    NOTE: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction. The arrow must point toward the engine.
  1. Install the MAF/IAT sensor to the air cleaner assembly.
    2. CAUTION: Refer to Fastener Caution .
  2. Tighten the MAF/IAT sensor adapter clamp to 4 N.m (35 lb in).
    3. Fig 2: View Of MAF/IAT Sensor & Engine Wiring Harness Electrical Connector
    GM1960228Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (2) to the MAF/IAT sensor (1).
  4. Install the air cleaner outlet resonator. Refer to Air Cleaner Resonator Outlet Duct Replacement .
scientia non olet · About LEMON Manuals