LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction) >> Repair Instructions >> Knock Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Wiring Harness Electrical Connector & Sleeve
    GM1964987Courtesy of GENERAL MOTORS CORP.
  1. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  2. Working through the wheel well opening, disconnect the engine wiring harness electrical connector (3) from knock sensor.
    3. Fig 2: Right Side Knock Sensor & Bolt
    GM1402140Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor bolt (739) and knock sensor (718).
scientia non olet · About LEMON Manuals