LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Vent Solenoid & Retainer
    GM1964765Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid (2).
  2. Slide the EVAP canister vent solenoid onto the bracket until the retainer (1) engages the clip.
    3. Fig 2: Locating Quick Connect Fittings
    GM1964762Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister vent solenoid line quick connect fitting (1) to the auxiliary EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Connect the fuel fill pipe vent pipe quick connect fitting (2) to the EVAP canister vent solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: View Of EVAP Canister Vent Solenoid Wiring Harness Electrical Connector
    GM1964761Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis wiring harness electrical connector (1) to the EVAP canister vent solenoid.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals