LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister, Bracket & Bolt
    GM1964900Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister (2) to the bracket (3).
    2. CAUTION: Refer to Fastener Caution .
  2. Install the EVAP canister bolt (1).

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: View Of EVAP Canister Assembly & Bolts
    GM1964898Courtesy of GENERAL MOTORS CORP.
  3. Position and install the EVAP canister assembly (2) to the fame bracket tab.
  4. Install the EVAP canister bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    5. Fig 3: Locating Quick Connect Fittings
    GM1964897Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP pipe quick connecting fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Connect the fuel tank EVAP line quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  7. Connect the fuel tank EVAP line quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals