LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Pipe Fitting Seal Replacement

Transmission Fluid Cooler Pipe Fitting Seal Replacement

WARNING: This page is about a different variant/trim than selected.
Fig 1: Transmission Fluid Cooler Pipe Fitting Seal Replacement
GM1970145Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transmission fluid cooler pipes from the transmission. Refer to Transmission Fluid Cooler Pipe Replacement .
1 Trans Fluid Cooler Pipe Fitting Seal (Qty: 2)

Special Tools

  • DT 47770  Seal Installer
  • J 45201  Cooler Line Seal Remover