LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Range Selector Lever Nut
    GM1970155Courtesy of GENERAL MOTORS CORP.
  1. Install the range selector lever (2).
    2. CAUTION: Refer to Fastener Caution .
  2. Install the range selector lever nut (1).

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

    3. Fig 2: Range Selector Lever Cable & Retainer
    GM1970184Courtesy of GENERAL MOTORS CORP.
  3. Install the range selector lever cable (2) to the cable bracket.
  4. Install the range selector lever cable retainer (1).
  5. Connect the range selector lever cable (2) to the range select lever.
    6. Fig 3: Range Selector Lever Cable Heat Shield Bolts
    GM1970183Courtesy of GENERAL MOTORS CORP.
  6. Install the range selector lever cable heat shield (2).
  7. Install the range selector lever cable heat shield bolts (1).

    Tighten:  Tighten the bolts to 17 N.m (13 lb ft).

  8. Lower the vehicle.
scientia non olet · About LEMON Manuals