Sun Gear Shaft Installation
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Internal Gear - 2nd Position |
| 2 | Sun Gear Shaft Assembly - 1st Position |
| 3 | Sun Gear Shaft Retaining Ring Tip: Do not reuse the retaining ring. |
| 4 | Sun Gear Shaft Assembly Tip: When fully seated the sun gear shaft assembly will be dimension (a) below the mainshaft. Specification: Dimension (a) 3.3 mm (0.13 in) |