Output Speed Sensor and Case Extension Installation
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Gasket (2WD Output Only) |
| 2 | 2WD Output Housing Extension Assembly |
| 3 | A/Trans Rear Case Bolt M10 x 1.5 x 45 (Qty: 6)
CAUTION:
Refer to Fastener Caution
.
Tighten: Tighten bolt to 51-61 N.m (38-45 lb ft). |
| 4 | A/Trans Output Speed Sensor O-Ring Seal |
| 5 | A/Trans Output Speed Sensor Assembly |
| 6 | Vehicle Speed Sensor Bolt M6 x 1.0 x 20 Tighten: Tighten bolt to 9-13 N.m (80-115 lb in). |