Input Shaft, Sun Gear Carrier, and Sun Gear Removal
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Input Shaft Thrust Bearing |
| 2 | Input Shaft Assembly |
| 3 | Sun Gear Carrier Thrust Bearing - 1st Position |
| 4 | Internal Gear Retaining Ring - 1st Position
WARNING:
Use care when removing or installing the retaining ring, or bodily injury may occur. Tip: Discard the retaining ring. It is not reusable. |
| 5 | Input Shaft Fluid Seal Ring Tip: Discard the seal ring. They are not reusable. |
| 6 | A/Trans Torque Dampener Clutch Fluid Seal Ring Tip: Discard the seal ring. They are not reusable. |
| 7 | Input Shaft |
| 8 | Internal Gear |
| 9 | Sun Gear Carrier Assembly - 1st Position |
| 10 | Sun Gear Assembly - 1st Position |